Bevel Seat Fittings from VNE

Bevel Seat Fittings are used on process equipment and piping to ensure rigidity of the system. Bevel Seat Unions consist of a Threaded Bevel Ferrule mated with a Plain Bevel Ferrule. Both are offered in T304 and T316L material. Hex Union Nuts made of only T304 material are used to complete the union.

Gaskets for VNE’s Bevel Seat Unions are not required for positive shut-off. However, gaskets may be purchased upon request.

VNE’s Bevel Seat Fittings meet all 3A requirements and are available in 1˝ through 4˝ sizes.

Specifications:

Size Range: 1˝ OD - 4˝ OD

Finish:
No. 7 - ID & OD
No. 5 - OD only
No. 3 - ID only
No. 1 - unpolished

Materials:
T304
T316L

Limited Warranty

VNE Corporation products are warranted to be free from defects in material and workmanship for a period of one year from the date of shipment. Any product that proves to be defective shall be repaired or replaced at the option of VNE, providing it has been used as recommended and in strict accordance with recognized piping practices, and that has not been subject to extraordinary service, such as encountered under severe corrosive or abrasive conditions. VNE makes no warranties, express or implied, other than those listed above. VNE shall not be liable for any consequential, indirect, incidental or contingent damages.

 

STI is a Member or Affiliate of: