Tygon® UV Resistant Tubing will
meet UL 94V-0 and UL 94HB
Versatility in Chemical Resistance
Ideal for virtually any permanent or temporary chemical transfer application, Tygon® UV Resistant Tubing combines suppleness and flexibility with resistance to a wide range of chemicals. It shows exceptional resistance to strong acids and many alkalies.
The flexibility of Tygon® UV Resistant Tubing makes it quick and easy to put into service, providing considerable savings on installation time and cost.
Black in color, is is resistant to ultraviolet light, ozone and weathering, making it ideal for many outdoor applications. Standard inventoried sizes of Tygon® UV Resistant Tubing have sufficient wall thickness to block transmission of all UV light.
Excellent Burn Resistance
Tygon® UV Resistant Tubing will meet UL 94V-0 and UL 94HB flammability ratings. Specifying Tygon® UV Resistant Tubing for use in equipment that requires specific burn characteristics can help to simplify the approval process.
*Tygon® R-3400 tubing is not intended for use as an implant
Black in color, protects light-sensitive fluids
- Wide range of chemical resistance
- Excellent burn resistance
- Ozone and UV light resistant
- Low compression set; resists permanent deformation
- Available in clear formulation for fluid flow monitoring
Corrosive diffusible gases
- Acid and caustic transfer
- Fertilizer and pesticide dispensing
- Electrical insulation lines
- Ink and adhesive dispensing
- General maintenance
Tygon® R-3400 Tubing Typical Physical Properties
||Value or Rating
|Durometer Hardness - Shore A, 15 sec
|Tensile Strength - psi (MPa)
|Ultimate Elongation, %
|Tear Resistance - lb-f/inch (kN/m)
|Water Absorption, % - 24 hours @ 23ºC
|Compression Set Constant Deflection, % @
158ºF (70ºC) for 22 hours
||D395-02 - Method B
|Brittleness by Impact Temp - ºF (ºC)
|Max Recommended Operating Temp - ºF (ºC)
|Dielectric Strength - v/mil (kV/mm)
|Tensile Modulus, @ 100% Elongation, psi (MPa)
|Tensile Set, %
Unless otherwise noted, all tests were conducted at room temperature (73ºF). Values shown were determined
on 0.075" thick extruded strip or 0.075" thick molded ASTM plaques or molded ASTM durometer buttons.